So there is a bit of sentimental value in this flooring.
Tongue and groove flooring table top.
I painted the dresser antique tin and i like its industrial feel.
Table top from old tongue and groove maple flooring.
To begin cut all of the boards you want to use for your tongue and groove assembly to a length of at least one inch longer than the desired finished length using a circular saw or compound.
Attach the boards to the sides of the tabletop using 2 finish nails.
My wife and i met there.
My hubby carpenter cut the pieces of flooring to length.
The new top is old tongue and groove pine attic flooring from the early 20 s.
The maple flooring is from a local skating rink that was torn down after a flood.
To rip off the tongue and groove edges set the table saw to the width of the tongue groove and run the board through the saw.
Make sure the frame is the correct height so that the flooring boards will be flush to the top edge of the frame.
Steve and hannah are making tongue and groove flooring for a bathroom remodel.
The tongue and groove joint can be easily created using a router with a matched set of router bits or on a table saw using a stacked dado blade set.
How to make a reclaimed tongue groove table top.
Feb 1 2014 a table i made from leftover tongue and groove flooring.
This type of table top assembles the same way except that the table top will have grooves.
Long story short on the source of the flooring.
He cut off all the outside edges removing either tongue or groove to give it a more finished look.
Warning don t add glue to the tongue or the groove on hardwood boards.
Here are the steps we took to build the hardwood floor table top.
I made a frame of the same wood and it anchors the piece.