Tricks For Edge Of Laminate

If you are trimming laminate off of an inside cutout feed the router counterclockwise instead.

Tricks for edge of laminate.

Beginning with one end attach the laminate firmly to the edge of the counter and use your j roller to flatten and tighten it down. The tape will keep your bit from digging into the face assuming your edges are square to the top and also keeps excess glue off the front edges. The first thing to know when learning how to lay laminate flooring is that all laminate flooring will expand and contract due to temperature and humidity fluctuations. Lower the upper laminator roller.

Pull the laminate through the area where the upper and lower roller meet nip until it is about 1 foot past the rollers. Place the iron on the rag over top the laminate edge strip for 15 20 seconds. Notch and cut the first piece to fit and then slide it. Still wearing heat resistant gloves bend the heated and pliable section of the laminate over the curve slowly using your j roller to keep pressure against the strip.

Slowly move across the entire edge until it has completed bonded to the countertop. Feed the router clockwise around the outside of the workpiece to cut the laminate flush. Use tape to secure the laminate liner to the upper wind up shaft. The goal is to melt the glue on the back of the edge strip.

Set the laminator pressure at the oem s recommended setting to avoid wrinkles. Plan on a seam in the middle of the doorway. To allow for this expansion place 3 8 inch spacers along the wall to leave a consistent gap around the edges of the floor. A plastic laminate file is also an incredibly safe and easy tool to use.

For more home improvement tips and tricks please visit the family handyman website at. On counters i ll tape the top edge of the front strips before they re trimmed trim belt sand the top and stick the top piece of laminate. If the surface is really rough you can adjust the angle by eye but if the surface is relatively smooth you can gauge the position by how it feels. Push the piece you are holding into the first piece.

Masking tape works well for your burning issue. Slide both pieces over. Hold it in both hands on the surface you want to smooth and push. Place the block of wood on the end of the second piece of laminate.

It s easy to tell if you re in full surface contact or if the file is tilted on an edge. Once trimmed flush the edge of the laminate will be extremely sharp. Use the soft rubber mallet and the block of wood to secure the connection. Use a scrap piece of wood to push the edge backing glue into the particle board ensuring an evenly bonded surface.